ControlAction (IR, IR-to-RF, RS232, RS485, Digital Output, X10, etc.)
Command: 039[ActionID][Par1][Par2][Par3][Par4][Par5][Par6][Repeat]
|
This command instruct the product to to
start/exercise a specific Action.
The specific Action to be controlled is a set of parameters following the command 039
instruction.
See: Triggers
and Actions
The parameters are based on an 8 x 3-digit (24
characters) format:
CodeNumber + Parameter 1 + Parameter 2 + Parameter 3 + Parameter 4 + Parameter 5 +
Parameter 6 + Repeat
ActionID is on the range 201
- 299 and 701 - 799
Par1, Par2, Par3, Par4, Par5, Par6, Repeat is in the
range 000 - 255
The ActionID could be instructions on:
- how to built an InfraRed code ( Sony, Philips, Panasonic, Pioneer, and many many more )
- how to activate programmable delay between Actions
- how to control a digital output, ( OutputNumber, On (fixed or pulsed), Off or Toggle )
- how to control a devices by sending RS485 commands ( for example ICPDAS 7000-series
modules )
- how to control a devices by sending RS232 commands (screen, projectors, relays, ect.)
- how to control X10 commands ( IR, IR-RF, PowerLineCarrier )
- how to control Pioneer SR bus
Examples:
500 - Computer control of LinTronic Relay Box
533 - LinTronic Relays Box actions
701 - Bang&Olufsen (infrared codes)
705 - Philips RC5 (infrared codes)
707 - Lutron IR codes (infrared codes)
710 - X10 HomeAutomation Power Line Carrier signals, InfraRed,
RadioFrewuency
712 - BOSE (infrared codes, LifeStyle 28, 35, 38, 48)
713 - NEC (infrared codes, Pioneer SR bus codes)
716 - 32 BIT (infrared codes)
717 - Sony (infrared codes)
732 - RS232/RS485 commands
733 - HomeAutomation - Control of
Light, Curtains, Relay etc. by IR, IRRF, RS232, Digital Output
744 - HomeAutomation, ICPDAS relays and input
modules
745 - LinTronic Codeset - A must for manufacturers and
HomeAutomation installers/programmers
760 - CodesInFlash - See Yellow section in this link - click
761 - Digital Output signals
(TT455-RT-238, Conson Light System, etc.)
Example according to protocol
(found on: SUPPORT | PROTOCOL):
0100039701027053000000000000003249
01 = To Device address number 01
00 = From compouter
039 = Transmit Code
701027053000000000000003 = BangOlufsen code, LIGHT GO
249 = checksum
You can retrieve codes for controlling
InfraRed, Relays, RS232, Digital Output, etc. - from our internet database.
Please observe that the software in your product must be prepared to send specific
ActionIDs.
See our CodeCollection.
|